Brake lines suffer impact breakage and corrosion over time and need to be replaced.
Joining steel brake pipes.
And he said no problem with joining the.
My profile my preferences my.
I have to change the brake pipes on my son s car as they are rusted over the back axle.
It would therefore be easier if it is possible to shorten it flare the end and use a joining piece to new pipe for the remainder of the length.
No one seems to do steel connectors foe 1 4 inch pipe only brass ones and i am sure that i have been told not to use brass fittings.
Some say it is not possible with steel only copper.
Smaller lines are usually joined by socket welding or screwing.
Flaremaster joining brake pipes.
Joining two brake lines together with a new spliced section can be accomplished with a few specialty tools and some basic steps.
I have a bit of a prob i need to join two sections of 1 4 brake pipe.
Flaring steel brake pipes.
There are three main methods of joining pipes together and attaching fittings to them.
Some occasions call for replacing just a section of brake line rather than the entire length.
However these pipes can deteriorate to the point where they start to leak causing a dangerous loss of brake fluid and eventually partial or even complete failure of the braking system.
Lines of 2 inch or larger are usually butt welded this being the most economic leak proof method.